Leer

KNX USB Interface 310

This interface is for establish a bidirectional connection between a PC and the EIB/KNX installation bus. The USB connector has a galvanic separation from the EIB/KNX bus. Both ETS (Engineering Tool Software) versions ETS3 or later and some Visualization tools support this interface.
 
Typische Anwendung vom KNX USB Interface 310 (REG)

Mechanical data

  • Housing: plastic
  • DIN rail mounted device, width: 2 TE

Indicators

  • Signal LED (green) for USB-connection
  • Signal LED (yellow) for communication

Power supply

  • The part of circuit for communication over USB is supplied by the connected PC / Laptop, correct operation is signalled by the green LED (USB).
    Power consumption: < 200mW
  • The part of circuit for communication over EIB/KNX is supplied by EIB/KNX bus.
    Power consumption: < 300mW

Connectors

  • KNX connector
  • USB connector type B
  • Wire length max. 5m

Compatibiliy

  • ETS (Engineering Tool Software) ETS3 or higher
Cookies make it easier for us to provide you with our services. With the usage of our services you permit us to use cookies.